# Frost on your heat pump: normal defrost or a service call?

> Frost on the outdoor unit, a cloud of steam, a fan that stops: what a normal heat pump defrost looks like in an Aurora winter, and the signs that need service.

URL: https://sundogauroraheatpumps.com/blog/heat-pump-frost-and-defrost/

A frosted coil and a puff of steam on a cold morning are usually the system doing its job. Here is how to tell normal defrost from ice that needs a technician.

A white coat of frost on the outdoor coil on a cold Aurora morning does not mean anything is wrong. Every air-source heat pump collects frost when it heats in cold, damp air, and every one clears it with a defrost cycle. Manufacturers describe the cycle as lasting roughly 5 to 15 minutes, after which the unit goes back to heating.

What matters is the pattern. Light frost that comes and goes is normal. Thick ice that stays, a unit that seems stuck in defrost, or a house that stops warming is a reason to call us for a [heat pump repair](https://sundogauroraheatpumps.com/heat-pump-repair/) visit.

## Why the outdoor unit frosts in the first place

Moisture in the air freezes onto the finsWarm gas runs through the outdoor coil and melts the frost

In heat mode the outdoor coil runs colder than the air around it, because it is pulling heat out of that air. When the coil surface drops below 32°F, moisture in the air freezes onto the fins instead of dripping off.

The system watches for this. A defrost control, using sensors and timers set by the manufacturer, briefly reverses the refrigerant so warm gas runs through the outdoor coil and melts the frost. Most modern units use demand defrost, which starts only when frost is actually building and stops as soon as the coil is clear.

## What a normal defrost looks and sounds like

All of these are part of a normal cycle:

- A thin, even layer of white frost across the coil that clears within a cycle
- The outdoor fan stops while the compressor keeps running
- A whoosh or hiss as the refrigerant changes direction, at the start and end of the cycle
- A cloud of steam rising from the unit as the frost melts
- Water dripping from the base of the unit onto the pad or stand
- On a ducted system, backup heat coming on for a few minutes so the air from the registers stays warm

## Why some winter days bring more cycles than others

Frost depends on moisture as much as cold. A damp morning in the 20s or 30s, especially after a snowfall or with fog, puts the most water on the coil, so cycles come closer together. On a dry, very cold night there is less moisture to freeze, and the unit can run longer between cycles even though it is colder.

Wind matters too. Fine, blowing snow can be driven into the coil and trigger extra cycles, and a unit sitting under a roof edge collects drip that refreezes on the fins. Both are placement problems more than equipment problems, which is why we plan the outdoor spot carefully on every [heat pump installation](https://sundogauroraheatpumps.com/heat-pump-installation/). See our post on [outdoor unit placement](https://sundogauroraheatpumps.com/blog/heat-pump-outdoor-unit-placement/). For how output changes as the temperature falls, see our guide to [cold-weather heat pump performance](https://sundogauroraheatpumps.com/guide/cold-weather-heat-pump-performance/).

## Normal frost or a problem: how to tell

Look at the unit a few times over a cold day. A coil that never clears tells you far more than one glance at frost.

| What you see | Usually normal | Worth a service call |
| --- | --- | --- |
| Frost on the coil | Light, even frost that clears after a cycle | Thick or clear ice that stays on the coil all day |
| Defrost timing | A few minutes, then back to heating | Cycles that seem constant, or a unit that seems stuck in defrost |
| Ice location | Fins only, melting off the base | Ice building on the top, around the fan or encasing the base |
| Indoor comfort | House holds temperature through the cycle | Rooms cooling off, or air from the registers staying cool |
| Thermostat | Backup or auxiliary heat shows briefly during defrost | Auxiliary heat displayed most of the time |
| Sound | Whoosh at the start and end of a cycle | Grinding, rattling or a fan striking ice |

## What you can safely do before you call

### Fine to do

Brush loose snow away from the sides and top of the unit with a broom, and keep a clear path around it. Check that meltwater is not pooling and refreezing on a walkway. Make sure the thermostat is set to heat, not auto or cool, and note whether it shows auxiliary or emergency heat. Check or change the indoor filter if it is due. Note what you saw and when.

### Leave to us

Do not chip, pry or scrape ice off the coil, and do not pour hot water on it; the fins and tubing are thin and easy to puncture. Do not open the unit's access panels or try to start a defrost by hand. Avoid covering the unit with a tarp in winter, since it needs air moving through the coil. If ice is building up, switching the system to emergency heat keeps the house warm until someone looks at it.

## What we check when the ice will not clear

Persistent ice has several possible causes, and the symptom alone does not say which. On a repair visit we work through them and tell you what we found before we price anything.

### Airflow

A dirty coil, a blocked base or a slow outdoor fan leaves too little air moving through the fins.

### Defrost controls

A failed sensor, control board or relay can keep the unit from entering defrost, or end the cycle before the coil is clear.

### Refrigerant charge

A low charge drives the coil colder than it should run. That points to a leak, which we find before adding refrigerant.

### Reversing valve

The valve that switches between heating and defrost can stick, leaving the unit unable to warm its own coil.

### Drainage and placement

Meltwater that cannot drain away refreezes in the base, and roof drip lands on the coil. Sometimes the fix is a stand, a diverter or a better spot.

## What a defrost repair costs

Sundog's typical range for routine heat pump repair is $150 to $1,200. Major components such as a compressor or reversing valve fall in Sundog's typical range of $1,500 to $3,500. Your price comes from the visit and the written estimate. When a major part fails on an older system, we put repair and replacement side by side (see our [repair or replacement guide](https://sundogauroraheatpumps.com/guide/heat-pump-repair-vs-replacement/)).

Regular [heat pump maintenance](https://sundogauroraheatpumps.com/heat-pump-maintenance/) catches many of these causes early: a clean coil, a clear base and a checked charge going into winter. Our [maintenance checklist](https://sundogauroraheatpumps.com/guide/heat-pump-maintenance-checklist/) splits the jobs between you and a service visit, and the [backup heat guide](https://sundogauroraheatpumps.com/guide/heat-pump-backup-heat/) explains the auxiliary light during defrost. If your unit is icing now, [contact us](https://sundogauroraheatpumps.com/contact/) or call [(719) 417-2475](tel:+17194172475) and tell us what you are seeing.

## Questions people ask

### Is steam coming from my heat pump a sign of a fire or a fault?

No. During defrost the coil warms enough to melt its frost, and the meltwater turns to vapor in the cold air. Manufacturers describe it as normal and harmless. Smoke with a burning smell is different; switch the system off and call.

### How often should a heat pump defrost?

There is no single schedule. Demand-defrost units run a cycle only when frost is building, so you can see several in an hour on a damp morning and none on a dry, cold afternoon. Constant cycling or a cycle that never ends is the warning sign.

### Should I switch to emergency heat if the unit is iced over?

If the coil is encased in ice and the house is cooling off, emergency heat keeps you warm with the backup heat alone until a technician checks the unit. It costs more to run, so treat it as a stopgap, not a setting to leave on.

## Related services

Heat pump repair

Cool air in heat mode, ice that will not clear, a breaker that trips.

Heat pump maintenance

A heat pump works in both seasons, so it collects dust, cottonwood and ice all year.

Cold-climate heat pump installation

We choose cold-climate equipment from what it puts out at 5°F, size backup heat to the hours it falls short and set the outdoor unit where snow and meltwater cannot stop it.

## More guides

Cold-weather performance

A heat pump keeps heating when it is cold outside, just with less output as the temperature drops.

Backup heat

Backup heat covers the hours a heat pump cannot carry the house alone.

Heat pump maintenance checklist

A heat pump works in both seasons, so it gets checked for both: filters and snow by you, coils, drains, charge and controls on a visit.
