# How do you plan mini-split zones in an Aurora home?

> How to plan mini-split zones in an Aurora home: room loads, head placement, line-set and drain routes, and the limits of one outdoor unit serving many rooms.

URL: https://sundogauroraheatpumps.com/guide/mini-split-zone-planning/

Zones are drawn room by room: the load decides the head, the walls decide where it goes, and the routes outside decide what is practical.

## The short answer

Start with the rooms that need help, calculate each one's heating and cooling load, and give a room its own head only when its load and doors call for one. Then plan where each line set, drain and power run goes, and decide whether one multi-zone outdoor unit or separate single-zone units serve the rooms better.

## Size each room, not the floor

Square footage alone misleads, because two rooms of the same size can lose very different amounts of heat.

### What sets a room's load

Exterior walls, window area and direction, the ceiling or roof above, the floor below and air leakage. A bonus room over an unheated garage loses heat through five surfaces; a middle bedroom loses it through one or two.

### Why oversizing hurts

Mini-split heads modulate down, but only so far. A head too large for a small bedroom reaches its minimum output and still overshoots, so it cycles on and off and dries the air poorly in summer. We size each head to the room's calculated load, as in our [sizing guide](https://sundogauroraheatpumps.com/guide/heat-pump-sizing/).

## Where each head goes

The right wall is the one that lets the head reach the room and still gets the lines outside cleanly. We mark head locations on a sketch before the estimate, so how the room looks is settled early.

- A clear throw across the room, not blocked by a bed, shelving or a beam
- Clearance from the ceiling and side walls per the manufacturer's instructions
- Not directly over a desk chair or bed pillow, where the airflow is felt
- A route through the wall to the outside, or to a closet or attic chase
- A path for condensate that runs downhill, or room for a condensate pump
- Access to clean the filters and coil without moving furniture

## Line sets, drains and power

Every head needs a refrigerant line set, a condensate drain and a control cable back to the outdoor unit. The routes often decide the plan more than the room does.

Heads indoorsEach head: line set, condensate drain and control cableLine-hide cover down the outside wallBracket holds the outdoor unit above the snow lineClear path for defrost meltwater

### Inside the house

In finished basements the lines usually run through the joist bays; in additions and bonus rooms, through the attic. Every penetration is sealed and the lines are insulated their full length.

### Outside the house

Exterior runs go in a line-hide cover down the wall to the outdoor unit. Long runs need refrigerant added per the manufacturer's charging rules and have maximum lengths. The outdoor unit sits on a stand or bracket above the snow line with a clear path for defrost meltwater.

## One outdoor unit or several

A multi-zone outdoor unit can serve two to five heads from one location. It is not always the better choice.

### Multi-zone

One outdoor unit, one circuit, less space outside. But the outdoor unit has its own minimum output, and when one small bedroom calls for heat alone it can run inefficiently or short-cycle. Connected head capacity must also stay within the outdoor unit's limits.

### Separate single-zone units

Each room gets its own outdoor unit sized to it. More equipment outside and more circuits, but each zone modulates down to its own load. This suits rooms with very different loads or schedules, such as a basement office and a bedroom.

## Common Aurora layouts

Most ductless plans in Aurora-area homes start from one of these shapes.

### Bonus room over the garage

One head sized to the room, lines through the attic. Sundog's typical range for one cold-climate zone is $4,500 to $6,500.

### Finished basement

One head for an open family room, or two where a bedroom is closed off. Lines run through the joist bays.

### Tri-level upper bedrooms

Bedrooms that sit at the end of the duct run. Two heads, or three with the lower family room, on one multi-zone unit.

### A house with no ducts

Four or five zones covering the living areas and bedrooms, sometimes on two outdoor units, with [cold-weather capacity](https://sundogauroraheatpumps.com/guide/cold-weather-heat-pump-performance/) checked room by room.

## What zones cost

When every head is a cold-climate model, we budget by zone count. These are Sundog's typical ranges; the written estimate replaces them with your number. The [cost page](https://sundogauroraheatpumps.com/heat-pump-installation-cost/) lists every range.

| Cold-climate zones | Sundog's typical range |
| --- | --- |
| One | $4,500 to $6,500 |
| Two | $8,500 to $12,500 |
| Three | $12,500 to $18,500 |
| Four or five | $17,500 to $26,000 |

## How the zones run once installed

A good plan also covers how the zones are used, because mini-splits behave differently from a furnace.

### Steady setpoints

Heads recover slowly from a deep setback, so most rooms do best left at a steady temperature, with modest changes for sleeping. A room that must recover quickly on cold mornings may need a larger head or [backup heat](https://sundogauroraheatpumps.com/guide/heat-pump-backup-heat/).

### Drains in winter

A condensate line that exits onto a cold exterior wall can freeze where it drips. We route drains to run downhill and discharge where meltwater and ice do no harm, or into the house drain where the route allows. Filters and drains are checked on each [maintenance visit](https://sundogauroraheatpumps.com/heat-pump-maintenance/).

## Plan the zones on a sketch first

Call [(719) 417-2475](tel:+17194172475) or [request an estimate](https://sundogauroraheatpumps.com/contact/). We calculate each room, mark head locations and line routes on a sketch, and list each zone on the estimate. See [ductless installation](https://sundogauroraheatpumps.com/ductless-mini-split-installation/) for what the work includes, or [ducted vs ductless](https://sundogauroraheatpumps.com/guide/ducted-vs-ductless-heat-pump/) if you are still choosing a system.

## Questions people ask

### Does every room need its own head?

No. Open areas can share one head, and a small room with the door usually open may not need one. Closed rooms with their own loads usually do.

### How far can the outdoor unit be from a head?

Each model has a maximum line length and height difference set by the manufacturer. Longer runs need added refrigerant. We plan the outdoor spot so every line stays within those limits.

### Do mini-splits need backup heat in Aurora?

It depends on the room's load and the head's output at low temperature. Many rooms with a cold-climate head do without; a room that must stay warm in any weather may keep a backup.

## Related service

Ductless mini-split installation

A mini-split fixes the rooms your ducts never reached.

## More guides

Ducted vs ductless heat pump

Start with what is already in the house: the ducts, the rooms that give trouble and the panel.

Heat pump sizing

Size comes from what your house loses on a cold night and gains on a hot afternoon, matched to equipment by its output in the cold.

Cold-weather performance

A heat pump keeps heating when it is cold outside, just with less output as the temperature drops.

Electrical panel

Not always. The answer comes from the nameplate on the new equipment, what is already on your panel and a load calculation, not from the panel's size alone.

Heat pump maintenance checklist

A heat pump works in both seasons, so it gets checked for both: filters and snow by you, coils, drains, charge and controls on a visit.
