Heat Pump Replacement for Newer Homes in Commerce City, CO

Equipment installed when these homes were new is reaching twenty years. Replacing it is the moment to check whether the original size was ever right.

Heat pump outdoor unit in the side yard of a Commerce City two-storyThe same house in a thermal rendering
Daylight and thermal views of the same house: where it loses heat sets the load.

Last Updated: November 2026

Sundog replaces original furnaces and air conditioners with heat pumps in Commerce City. Much of the city's housing is young, and equipment installed when those homes were new is now at the age when compressors, inducers and coils start to fail. If you are facing that replacement, it is also the moment to check whether the original size was ever right.

We size from a room-by-room load calculation, with duct and airflow checks and a panel check, not from the label on the old unit. Sundog's typical range for a cold-climate ducted heat pump on suitable existing ducts is $13,000 to $25,000, and dual fuel with a new gas furnace runs $19,000 to $28,000. The visit and the itemized estimate turn those ranges into a price for your house.

Signs the original equipment is due

Each of these points toward replacement for a different reason.

The AC needs refrigerant every summer

A recurring leak on an older system turns a repair into a repair-or-replace question. Our repair vs replacement guide shows what tips it.

Short cycling on mild days

An oversized system starts and stops often and never runs long enough to dry the air. A load calculation can show that a newer, tighter house needs less capacity than its label.

You are not sure which electric utility serves the house

Commerce City lists two electric providers, United Power and Xcel Energy. The utility on your bill changes which rebate programs apply and which rates set the changeover.

Furnace and AC are the same age

Replacing both at once lets the furnace, coil and heat pump match. You choose dual fuel or an all-electric cold-climate system.

Heat pump services in Commerce City

Sundog provides these services to Commerce City homeowners:

How a Commerce City job usually runs

  1. Bill and address check

    We confirm which utility supplies electricity and gas at the address, since that decides which programs to check and which rates we use when setting a dual-fuel changeover. A recent bill from each utility is all we need.

  2. Load calculation against the nameplate

    Room-by-room load, static pressure and duct capacity, compared with what is installed now. If the two disagree, we show you both numbers.

  3. Vent and drain plan

    A condensing furnace needs PVC intake and exhaust and a condensate drain. A heat pump needs a path for defrost water outside. Both are planned at the visit.

  4. Permit

    The city's residential mechanical and gas permit covers furnace, AC and duct work. We confirm the electrical side with the city for the scope.

  5. Start-up and inspection

    Charge, airflow, both heat modes and the changeover checked and recorded before the city's gas and mechanical inspection.

Commerce City housing, utilities and permits

Commerce City's homes are younger than most of the metro's, and its utility map is not uniform.

2000About 21,000 residents2020About 62,000 residents020,00040,00060,000
Commerce City residents. The median home here was built in 2005.

Built largely after 2000

Census estimates put the median year built at 2005, give or take a year, among the newest of the places we serve. The city grew from about 21,000 residents in 2000 to about 62,000 in 2020. Houses built to newer energy codes generally lose less heat than older ones, which is why sizing down at replacement is a real possibility here rather than a gamble, and why we never match the old tonnage by default.

Gas heat and two electric utilities

About 75.3% of occupied homes heat with utility gas and 21.6% with electricity. The city lists Xcel Energy for gas, and both Xcel and United Power for electricity. Xcel's heat-pump rebate depends on the address, the equipment and the installer path, so the electric account matters. We check the current program dates and eligibility for your address before the estimate is final.

An Adams County city with its own permits

Commerce City sits in Adams County, but permits come from the city's own building division, not the county. The city lists new and replacement HVAC equipment among the work that needs a permit, and it publishes the 2021 International Mechanical Code it reviews to. We confirm the permit set for each address and list it on the estimate.

Matching the old size or sizing from the load

A smaller system costs less up front and runs longer, steadier cycles. The ducts that carried the old, larger unit usually have room to spare.

Match the old nameplateSize from the load calculation
Starting pointThe label on the old unitA room-by-room load calculation
Mild-day behaviorCan short cycle if the old unit was oversizedLonger, steadier runs that dry the air
DuctsSized for the old unitChecked with static pressure; a smaller system often has room
BackupWhatever came with itSized to the gap: furnace changeover or staged strip

Replacing original equipment in a 2000s Commerce City two-story

New condensing furnace with PVC intake and exhaust pipes in a basement
Commerce City: New condensing furnace with PVC intake and exhaust pipes in a basement.
The same scene in a thermal rendering
The same scene in a thermal view.
Project price
$22,400
On site
3 days
Where
Commerce City
The house
2000s two-story, unfinished basement

Much of Commerce City's housing went up in the 2000s, and that builder-grade equipment is now reaching twenty years. In this two-story, about 2,300 square feet over an unfinished basement, the original 4-ton AC needed refrigerant every summer, the 80% furnace's inducer was getting loud, and the system short cycled on mild days.

The nameplate said 4 tons. Our load calculation for this tighter, newer envelope said 3. Matching the old size was the easy answer, and it was also why the old unit short cycled, so we replaced down: a 3-ton cold-climate variable-speed heat pump paired with a new 96% two-stage furnace and matched coil. The owners kept gas for the coldest stretches.

The furnace change brought its own work. A condensing furnace vents through PVC, so we ran about 18 feet of 2-inch intake and exhaust out the rim joist, holding the terminations clear of windows and the narrow side-yard line, and sent condensate through a neutralizer to the floor drain. That left the water heater venting alone on a flue sized for two appliances, so we relined it and ran a combustion test on both.

The ducts were sized for 4 tons, which gave a 3-ton variable-speed blower plenty of room. We set the changeover point, commissioned charge, airflow and both heat modes, and booked the city's gas and mechanical inspection.

When a new furnace is part of the job

Many Commerce City owners keep gas for the coldest stretches, so a replacement often pairs a cold-climate heat pump with a new condensing furnace. That furnace changes more than the box in the basement. It vents through PVC rather than the old metal flue, which means planning intake and exhaust terminations that stay clear of windows, doors and a narrow side-yard property line. Its condensate needs a drain, and we run it through a neutralizer to a floor drain or pump.

The water heater is the other half of the check. When the old furnace leaves a shared flue, the water heater can end up venting alone on a flue sized for two appliances. We look at that on the visit and price a liner or other correction as its own line if it is needed, then run a combustion test after the install.

What a Commerce City replacement estimate lists

Every line below appears separately, so two quotes that name the same equipment can still be compared item by item:

  • Outdoor unit and indoor coil or air handler, with model numbers and low-temperature capacity
  • A new condensing furnace where the job is dual fuel, with its PVC venting and condensate drain
  • Water-heater flue correction and a combustion test when the furnace leaves a shared flue
  • Removal of the old equipment with refrigerant recovered
  • Pad or stand, line set and disconnect, plus any new circuit
  • The city permit and inspection
  • Start-up readings, model numbers and rebate paperwork, all handed over at the end

Send us the nameplate

A photo of the outdoor unit's label and the furnace data plate tells us the age, size and refrigerant before we visit. Tell us which utility bills you for electricity too. Call (719) 417-2475 or get an estimate.

Get an Estimate

Heat pump questions in Commerce City

What does heat pump replacement cost in Commerce City?

Sundog's typical range for a cold-climate ducted heat pump on suitable existing ducts is $13,000 to $25,000, and dual fuel with a new gas furnace is $19,000 to $28,000. Venting changes, a flue liner for the water heater and any duct or electrical work are listed separately on the written estimate after the visit.

Can I go down a size when I replace my system?

Often, yes, if the load calculation supports it. Many newer homes lose less heat than their original equipment was sized for. A right-sized variable-speed system runs longer, quieter cycles and controls humidity better than an oversized one.

Does it matter if United Power supplies my electricity?

Yes. Xcel's heat-pump rebate depends on Xcel service at the address, along with the equipment and the installer path. If United Power supplies your electricity, we check what programs apply to your account before the estimate is final.

Do I need a permit to replace my furnace and AC in Commerce City?

Yes. Commerce City requires a permit for new and replacement HVAC equipment, through its residential mechanical and gas permit. The city's inspection follows the install, and we confirm the permit set for your scope.

Is a twenty-year-old system worth repairing?

Sometimes, when the failed part is minor and the rest of the system is sound. With a major part on an older system, especially one with a repeat leak, we put repair and replacement prices side by side so you can decide.

Nearby areas

Get an estimate for your Commerce City house

Tell us about the house and the rooms that give you trouble. We come back with a first range from our typical rates and a time for the site visit.

CallGet an Estimate