Last Updated: November 2026
Sundog installs dual-fuel and all-electric heat pumps in Centennial. Most homes here heat with gas, so the first question we ask is about your furnace. If it still has good years left, a heat pump can replace the AC and carry most of the heating season, and the furnace takes over below a changeover point we set with you.
That decision starts at the visit: a room-by-room load calculation, duct and airflow checks and a panel check, plus a close look at the furnace's age, blower and the space above it for a coil. Sundog's typical range for dual fuel with a new gas furnace and cold-climate heat pump is $19,000 to $28,000. Keeping a sound furnace takes the furnace out of the price, and the written estimate shows exactly what remains.
Four starting points in a Centennial house
The furnace's condition is the hinge in all four.
The AC quit and the furnace is fine
This is the classic dual-fuel moment. We check the furnace blower and the cabinet space for a matched coil, then price a heat pump with your furnace next to a plain AC replacement.
Both are original to the house
With the furnace near the end, the choice is a new furnace plus heat pump or an all-electric conversion. The load calculation and the unit's 5°F output decide whether the backup is gas or a staged electric strip.
Upstairs bedrooms run warm in summer
Two-story homes often split comfort by floor. We measure room airflow and the upstairs returns before blaming the equipment; see ductwork for heat pumps.
You want to know where to set the changeover
The changeover comes from the house's heat loss, the heat pump's low-temperature output and your gas and electric rates. Our operating cost guide explains the trade.
Heat pump services in Centennial
Sundog offers these heat pump services to Centennial homeowners:
- Dual-fuel heat pumps paired with your existing furnace or a new one
- Ducted heat pump installation with airflow and return checks before sizing
- Cold-climate systems for owners who want to carry more of the winter on electricity
- Heat pump replacement for older heat pumps and ACs
- Maintenance that includes checking the changeover and backup settings
How a Centennial job usually runs
Furnace first
Age, visible condition, blower type and the cabinet space above it. This tells us whether dual fuel makes sense before anything else is priced.
Load and airflow
Room-by-room load calculation, static pressure and the upstairs return path. In a two-story house we also read supply airflow in the upstairs bedrooms, because a dual-fuel system that heats well can still cool the second floor poorly if the returns up there are small.
Controls plan
Dual fuel needs more thermostat conductors than a basic heat-and-cool setup, plus an outdoor sensor. We check the existing wire run.
Permit
A City of Centennial mechanical permit, with electrical work added where a new circuit is part of the scope.
Commissioning
Both heat modes and cooling run and recorded, the furnace blower matched to the heat pump's airflow and the changeover tested before inspection.
Centennial homes and the dual-fuel decision
Centennial is a young city with established housing, and both facts shape the job.
Houses from the early 1980s
Census estimates put Centennial's median year built at 1983, give or take a year. A furnace in a house of that age may already have been replaced once, which can leave a newer furnace sitting under an older coil and AC. That pairing is exactly where dual fuel fits best, because the part that failed is the part a heat pump replaces.
Gas is the norm here
About 77.4% of occupied homes heat with utility gas and 20.6% with electricity, one of the higher gas shares among the places we serve. The furnace already in the basement can be the backup half of the system. Whether Xcel's heat-pump rebate applies depends on your address, the equipment and the installer path, so we check the current program dates before the estimate is final.
A city since 2001
Centennial incorporated in 2001 from unincorporated Arapahoe County and runs its own building permits. Its permit categories include a simpler path for like-for-like HVAC replacement. Adding a heat pump where there was an AC, a new circuit or new controls can fall outside that category, so we confirm the permit type for your scope.
Plain AC swap or a heat pump with your furnace
When the furnace is not worth keeping, we say so and price a replacement of both halves against the dual-fuel option.
| AC replacement | Heat pump with existing furnace | |
|---|---|---|
| Cooling | Yes | Yes |
| Heating | Furnace all winter | Heat pump most of the season, furnace below the changeover |
| Added work | Coil and condenser | Coil, outdoor unit, dual-fuel controls and an outdoor sensor |
| Needs | A matched coil | A furnace worth keeping and a blower that suits the heat pump's airflow |
What a dual-fuel job in Centennial looks like


- Project price
- $13,900
- On site
- 2 days
- Where
- Centennial
- The house
- 1980s two-story with basement
The AC quit in June, the compressor wouldn't start, and the coil above the furnace was corroded through. The furnace under it, though, was a 96% two-stage unit about eight years old with an ECM blower, and it was sized right for this mid-1980s two-story of about 2,100 square feet. Most Centennial homes heat with gas, so a lot of houses here already own the backup half of a dual-fuel system.
That set the scope: we kept the furnace and replaced only the cooling side with a 3-ton cold-climate variable-speed heat pump and a matched cased coil. A plain AC swap was the other choice on the table, but for little more work the house got electric heat for most of the season.
The new coil stood taller than the old one, so we built a 3-inch sheet-metal transition into the existing supply plenum instead of cutting the trunk. A 40-foot 3/8 x 7/8 line set ran to a side-yard pad on risers, set off the bedroom window. The old 4-wire thermostat cable couldn't carry dual-fuel control, so we pulled new 18/8 cable and added an outdoor sensor.
After evacuation and charge, we matched the furnace blower profile to the heat pump's airflow and set the changeover point from the load calculation and the heat pump's low-temperature output. We commissioned both heat modes and cooling, then the city's inspector signed off.
How we set the changeover point
There is no single right temperature for a dual-fuel system to switch to gas, and we do not publish one. We start with the load calculation, which tells us how much heat the house loses as the outdoor temperature falls. Then we plot the heat pump's published output against it. Where the two lines cross is the balance point, the temperature below which the heat pump alone cannot keep up.
The changeover can sit at or above that balance point, depending on your rates. When gas is cheap relative to electricity, a higher changeover lets the furnace carry more of the cold weather. When electricity is the better buy, the heat pump runs lower. We show you both lines on paper and set the thermostat with you, then leave the settings in writing so a future thermostat change does not quietly undo them.
Rebates and paperwork for a Centennial install
Incentives change more often than equipment does, so we treat them as something to check for each job rather than a fixed discount.
Xcel's heat-pump rebate
Xcel Energy runs a residential heat-pump rebate for qualifying equipment at qualifying service addresses, with its own installation and application deadlines. Check the current program dates. Eligibility depends on your address, the equipment and how the job is installed, so we check what applies before the estimate is final and list what the program needs from you. The incentive checklist lists what to keep.
What you get from us
Model numbers, start-up readings and rebate paperwork are left with you after the job. The federal 25C tax credit ended for systems installed after 2025, so it no longer applies to a new install. Our rebates guide covers the programs in more depth.
Bring us your furnace label
A photo of the furnace nameplate and the failed AC's label lets us start the dual-fuel conversation before we arrive. We reply with a first range from our typical rates and a visit time. Call (719) 417-2475 or get an estimate.
Get an EstimateHeat pump questions in Centennial
What does a dual-fuel heat pump cost in Centennial?
Sundog's typical range for dual fuel with a new gas furnace and cold-climate heat pump is $19,000 to $28,000. When your existing furnace stays, the furnace drops out of the price. An all-electric cold-climate ducted system on suitable ducts is $13,000 to $25,000. The site visit and written estimate set your number.
Is my furnace good enough to keep for dual fuel?
We look at its age, condition, efficiency type and blower. A variable-speed or ECM blower that can match the heat pump's airflow, and room in the cabinet for a matched coil, make a furnace a good partner. A furnace near the end of its life usually is not.
At what temperature should the system switch to gas?
It depends on your house and your rates. We find the balance point from the load calculation and the heat pump's published output, then set the changeover with you based on what Xcel charges you for gas and electricity.
Does Centennial require a permit to add a heat pump?
Yes. The City of Centennial issues the mechanical permit, and electrical work is permitted when a new circuit is part of the job. Like-for-like replacements have a simpler category, and we confirm which one your scope falls under.
Will I need new thermostat wiring for dual fuel?
Often. Dual fuel needs more conductors than a basic heat-and-cool setup, plus an outdoor sensor. If the existing cable is too small, we pull a new run and list it on the estimate.

