Furnace-to-Heat-Pump Conversions in Thornton, CO

Your furnace has quit. Before you buy another one, see what the other two options cost for your house.

Heat pump outdoor unit in the side yard of a Thornton two-storyThe same house in a thermal rendering
Daylight and thermal views of the same house: where it loses heat sets the load.

Last Updated: November 2026

Last Updated: November 2026

When a furnace fails in a Thornton house built in the 1990s, it is often the original, and the AC beside it is usually the same age. That moment is the easiest time to change how the house heats, because you are buying equipment either way.

Sundog plans heat pump installation in Thornton with three options priced side by side: a new furnace with a heat pump, a heat pump on a kept or new furnace as dual fuel, or a full conversion to all-electric. The panel check on the first visit decides which of them your service can carry.

Where Thornton conversions start

Thornton is a big city, with more than 50,000 occupied homes, and the starting points vary. These are the ones we hear most.

  • The furnace stops in autumn and the repair quote is large for its age. You want to know if all-electric is realistic before buying another furnace.
  • The AC still runs, but on R-22, an outgoing refrigerant, and you prefer to replace both at once than one now and one later.
  • The house already has an electric dryer and range, and you are unsure the panel can take a heat pump and backup heat on top.
  • You want to stop paying for gas heat but keep the gas water heater, and wonder if that split makes sense.
  • You want cooling upgraded too. A heat pump replaces the AC as part of the same job.

Services in Thornton

Conversions and dual fuel

Furnace-to-heat-pump conversions with an air handler and staged electric backup, dual fuel with a new or kept furnace, and cold-climate heat pumps chosen by 5°F output.

Everything else

Heat pump replacement, ductless heads for rooms outside the duct system, repair and maintenance.

How a Thornton job usually runs

  1. Panel first

    Clamp readings and a load calculation on the electrical service, so you know what fits before you pick an option.

  2. House load

    A room-by-room heat load and a static-pressure test. Sizing comes from these, not from the old furnace's rating, and it often comes in smaller than the old equipment.

  3. Three prices

    Furnace and heat pump, dual fuel, all-electric. Each on its own estimate with model numbers and low-temperature capacity.

  4. Permits and start-up

    Inside city limits the City of Thornton issues the mechanical and electrical permits. We confirm for your address, install, commission and stage the backup.

When the furnace quits in cold weather

A dead furnace in November puts pressure on the decision. A few things keep it from being a rushed one.

Ask what failed

An inducer motor, a control board or an igniter can sometimes be replaced to buy a season, even on an older furnace. We tell you what the repair costs and what else is near the end, so you can choose between a short-term fix and the bigger decision.

Keep the house safe meanwhile

Plug-in heaters on separate circuits, never an oven or gas range for heat, and pipes on outside walls watched in a hard freeze. If the furnace smells of gas or the carbon monoxide alarm sounds, leave and call the gas utility first.

Order once

Equipment ordered before the panel and load are checked is equipment that may not fit. The visit comes first, then the order, then the install.

What shapes a Thornton estimate

Three local facts drive most of the decisions here.

A late-1990s median

Census survey data puts Thornton's median year built at 1997, within about a year. Original furnaces and ACs from that era are now past typical replacement age, so many owners face this choice in the same few years. Ducts from the 1990s are often sound enough for a heat pump, though we still measure.

Panels set the menu

About 70% of occupied homes heat with utility gas and 28% with electricity. In a gas home, the panel's rating and what already sits on it, often an electric dryer or range, decide how much room is left for an electric backup strip. That is why the panel load calculation comes first. Our panel guide explains it.

Two utilities, two counties

The City of Thornton notes that Xcel Energy or United Power supplies a home's electricity and gas depending on location, and the city spans Adams and Weld counties. Rebate programs follow the utility, so we confirm yours from the address or a recent bill before the estimate is final.

The three options compared

Here is how the options usually differ in a Thornton house of this age. The prices are Sundog's company ranges, the same in every area we serve; your visit and the written estimate fill in the real numbers. For a first range before the visit, try the cost estimator.

New furnace + heat pumpDual fuel, kept furnaceAll-electric conversion
Heats withHeat pump, gas below changeoverHeat pump, gas below changeoverHeat pump, electric strip when needed
Panel needOne outdoor circuitOne outdoor circuitOutdoor circuit plus backup strip
Gas serviceStaysStaysHeating branch capped; water heater may stay on gas
Sundog's typical range$19,000 to $28,000Within $13,000 to $25,000Within $13,000 to $25,000

Is all-electric right for your house?

It fits well when

The panel has room for the outdoor circuit and a staged backup strip, the ducts carry the airflow, and a cold-climate model covers most of your heat load at 5°F. Staging the strips and setting an outdoor lockout keeps them off in mild weather. Our backup heat guide covers how.

Dual fuel fits better when

The panel is tight, the furnace is young, or your rates make gas cheaper for the coldest hours. You can convert fully later, and we size today's equipment so that step stays open. The heat pump or furnace guide walks through the trade-offs.

Why we price all three

  • A failed furnace pushes people toward the familiar option. Seeing three prices on one visit lets you choose on facts.
  • The panel calculation stops a plan that needs a service upgrade from surprising you halfway through.
  • Replacing a heat pump's refrigerant lines when the old ones are the wrong size or type avoids a weak point in a new system.
  • We check rebate eligibility for your address before the estimate is final, and leave the model numbers and paperwork the program asks for. Our rebate guide explains what to expect.

A typical Thornton furnace-to-heat-pump conversion

New air handler with electric heat strip and a fused disconnect in a basement
Thornton: New air handler with electric heat strip and a fused disconnect in a basement.
The same scene in a thermal rendering
The same scene in a thermal view.
Project price
$19,600
On site
2 days
Where
Thornton
The house
Late-1990s two-story, 150-amp panel

It was late autumn and the furnace in this late-1990s Thornton two-story had stopped: inducer motor and control board both gone, on a 27-year-old 80% unit. The original AC still ran, but on R-22. Rather than buy another furnace, the owners wanted to convert to all-electric.

The question that decided the job was the panel. Houses of this age often have 150-amp service, and this one also carried an electric dryer and range. We took clamp readings and ran a load calculation before ordering anything. It showed room for a 30-amp outdoor circuit and a 60-amp circuit for 10 kW of backup, so no service upgrade was needed.

The load calculation for about 1,900 square feet came to 3 tons. We recovered the R-22 and removed both old units. The old line set was the wrong size for the new refrigerant, so a new 35-foot 3/8 x 3/4 line ran along the basement ceiling to the patio side. A matched variable-speed air handler with the 10 kW strip went where the furnace had stood, and the cold-climate outdoor unit got a fused disconnect.

We staged the backup and set an outdoor lockout so the strips stay off in mild weather and come on only when the heat pump falls behind. After evacuation, charge and commissioning, the gas branch was capped; the water heater stayed on gas. The city's inspection followed.

Nearby areas

Northglenn

Thornton's neighbor to the west, with older mid-1970s housing where multi-level comfort and ductless zones come up more often than conversions. Northglenn service area.

Federal Heights

Southwest, a smaller city with late-1980s housing on average and a larger share of electric heat. Federal Heights service area.

Welby

South, unincorporated Adams County with mid-1970s housing and county permits rather than city ones. Welby service area.

See all three prices before you buy a furnace

Send us a photo of the panel label and the furnace and AC nameplates. We start with a first range from our typical rates, then book the visit that checks the panel, the ducts and the house. Call (719) 417-2475 or request an estimate.

Get an Estimate

Heat pump questions in Thornton

How much does a furnace-to-heat-pump conversion cost in Thornton?

Sundog's typical range for a cold-climate ducted heat pump on suitable existing ducts is $13,000 to $25,000, which covers most all-electric conversions without a service upgrade. Dual fuel with a new furnace runs $19,000 to $28,000. The visit and written estimate set your price.

Will my 150-amp panel handle an all-electric heat pump?

Often, but not always. It depends on what is already on it, especially an electric dryer, range or car charger. A load calculation with clamp readings answers it before anything is ordered.

Can I keep my gas water heater?

Yes. Converting the heating to a heat pump does not require changing the water heater. We cap the furnace's gas branch and leave the water heater's supply in place.

Who issues the permit in Thornton?

Inside city limits, the City of Thornton issues the mechanical and electrical permits and inspects the work. We confirm the permit path for your address.

Is my utility Xcel or United Power?

Both serve parts of Thornton. Your bill shows which one serves you, and we confirm it from the address, since rebate programs depend on the utility.

Nearby areas

Get an estimate for your Thornton house

Tell us about the house and the rooms that give you trouble. We come back with a first range from our typical rates and a time for the site visit.

CallGet an Estimate