Last Updated: November 2026
Last Updated: November 2026
In a multi-level Northglenn house, the bedrooms can bake on a July afternoon while the lower family room needs a sweater in January, all on one thermostat. The furnace and AC are often working fine. The house is simply asking them to do different jobs on different floors.
Sundog handles ductless mini-splits and heat pump installation in Northglenn starting from room-by-room loads on every level, plus duct and airflow checks and a panel check. Then we show you whether ductless zones, a duct change or a new central heat pump fixes it, each priced on the written estimate.
What Northglenn owners usually describe
Hot bedrooms upstairs
The upper level sits under the roof at the end of the longest duct runs. In summer the AC satisfies the thermostat downstairs long before those rooms cool, so they stay warm into the night.
A cold lower level
A family room partly below grade loses heat into the ground and gets little supply air. It stays cold in winter whatever the thermostat says.
Central system still sound
The furnace and AC work, so replacing them feels like the wrong fix. Often it is. Ductless heads can treat the problem rooms and leave the central system alone.
Everything due at once
The furnace and AC are both old, and you want one plan that fixes comfort and replaces equipment. That is a replacement or dual-fuel job with zoning in mind.
Services in Northglenn
Zones and ductless
Ductless mini-splits with one head or several on a multi-zone outdoor unit, each sized to its own room, using cold-climate models where a room must stay warm in a cold snap.
Central systems
Ducted heat pumps, cold-climate equipment, dual fuel, repair and maintenance for ducted and ductless systems.
How a Northglenn job usually runs
Every level measured
Room loads upstairs, on the main level and below grade, plus supply airflow at the far rooms and static pressure at the furnace.
Head and line plan
For ductless, we mark head locations, line routes, condensate paths and the outdoor stand on a sketch before the estimate.
Permits
Northglenn's building division lists furnace work among the jobs that need a permit, and the contractor pulls it. We confirm mechanical and electrical permits for your address.
Commission each zone
Every flare torqued, every line pressure-tested and pulled to vacuum, each zone started on its own, and the readings and model numbers left with you after the city inspection.
What Northglenn's housing means for comfort
Three things about Northglenn guide our first look at a house, before we have seen a single room.
Mid-1970s housing
The American Community Survey puts Northglenn's median year built at 1974, within about two years. Houses of that period often have one central system feeding several levels from a single thermostat, with duct runs sized for a furnace. That combination is what makes uneven floors the most common comfort complaint we look for here.
Gas heat with a real electric share
About 67% of occupied homes heat with utility gas and about 29% with electricity. In a gas home, ductless heads can carry the problem rooms while the furnace keeps the rest. In an electric home, heads or a ducted heat pump replace resistance heat, and the panel calculation starts from what that heat draws today.
City permits, two counties
Northglenn is an incorporated city spanning Adams and Weld counties, with its own building division at City Hall. Mechanical and electrical permits come from the city, and we confirm requirements and the utility serving the address before the estimate is final.
Duct zoning or ductless heads
Both can fix uneven floors. Which one fits depends on what the ducts can deliver.
Duct zoning
Motorized dampers send air where the thermostat calls for it. It works when the ducts to the problem level are large enough to carry the air. Dampers only redirect air the ducts can already carry, so when the upper branches are long and narrow, zoning alone leaves those rooms short.
Ductless heads
A head in each problem room heats and cools it directly, on its own thermostat, sized from that room's load. The central system keeps serving the main level, and several heads can share one outdoor unit. Our zone planning guide and ducted or ductless guide cover the trade-offs.
Multi-level details that change the install
Below-grade walls
A half-buried room's outside wall may be partly below the soil line. The wall penetration has to sit well above grade, and when condensate cannot drain by gravity, a small pump lifts it to a drain or outside.
Upper-level heads
Heads on upper exterior walls are reached from the side yard, and line sets run down to the outdoor unit in one covered line-hide. We plan the route so the outside of the house stays tidy.
Where the head sits in the room
A wall head needs a clear spot high on an outside wall, away from curtains and not blowing straight at a bed or sofa. In bedrooms we favor the wall opposite or beside the bed. We mark each location on the sketch so you approve how the room will look before anything is drilled.
Why we size room by room
- An oversized head in a small bedroom short-cycles and leaves the air clammy, so each head matches its own room's load.
- Leaving a sound central system in place avoids replacing equipment that is not the problem.
- When the central system does need replacing later, the heads keep working, and the new equipment can be sized for the levels it still serves, often smaller than before.
- Cold-climate heads keep a below-grade room warm in a cold snap, where a standard unit loses output.
- We check rebate eligibility for your address and equipment before the estimate is final. See our incentive checklist.
What a split-level mini-split job in Northglenn looks like


- Project price
- $15,800
- On site
- 3 days
- Where
- Northglenn
- The house
- 1970s tri-level split-level
Northglenn's housing centers on the 1970s, the split-level era, and those houses share a complaint: one thermostat, three levels. In this mid-1970s tri-level, the upstairs bedrooms baked on summer afternoons while the family room, half below grade by the garage, stayed cold all winter. The furnace and AC worked fine; the house just asked them to do three jobs at once.
Duct zoning came up, but the upper branch ducts were the longest and smallest in the house, and dampers can't send air that never arrives. So we left the central system serving the main level and added a 2-ton cold-climate multi-zone outdoor unit with three heads: 9,000 BTU in each upstairs bedroom and 12,000 in the family room, each sized from its own room load.
The split-level shaped the details. The family-room head's wall was partly below the outside grade, so we cored its penetration well above grade, and since condensate couldn't fall to daylight from there, we added a small pump to lift it. The upper heads went on exterior walls reached by ladder from the side yard. Line sets of about 25, 35 and 20 feet ran in one short PVC line-hide to the stand.
We torqued every flare to spec, nitrogen-tested and pulled each line to vacuum, then commissioned each zone on its own. The outdoor unit went on one 25-amp circuit. The city's mechanical and electrical inspection closed the job.
Northglenn prices
Sundog's ranges are the same in every area we serve. For ductless, the number of heads, cold-climate models and the line routes move the figure most. For a first range before the visit, try the cost estimator.
| Work | Sundog's typical range |
|---|---|
| Ductless, one zone | $4,500 to $9,500 |
| Ductless, two to four heads | $9,000 to $18,000 |
| Cold-climate ductless, three zones | $12,500 to $18,500 |
| Cold-climate ducted heat pump, suitable existing ducts | $13,000 to $25,000 |
| Ductless repair | $150 to $1,500 |
Nearby areas
Thornton
Just east, a larger city of late-1990s homes where furnace failures often lead to conversions. Thornton service area.
Federal Heights
Southwest, late-1980s housing with a higher share of electric heat. Federal Heights service area.
Welby
South, unincorporated Adams County with mid-1970s housing much like Northglenn's. Welby service area.
Tell us which level bothers you
Which rooms, which season, and where the thermostat sits. Photos of the furnace label and the panel help, and so does a rough sketch of the levels. We give you a first range from our typical rates, then book the visit. Call (719) 417-2475 or request an estimate.
Get an EstimateHeat pump questions in Northglenn
What do mini-splits cost in a multi-level Northglenn house?
Sundog's typical range for ductless with two to four heads is $9,000 to $18,000, and a single zone runs $4,500 to $9,500. Cold-climate heads and longer line routes push toward the upper end. The site visit and written estimate set your price.
Do I have to replace my furnace and AC to fix uneven floors?
No. If the central system is sound, ductless heads can treat the problem rooms while it keeps serving the main level. We measure first and tell you which approach fits.
Can a mini-split heat a below-grade family room in winter?
Yes, when the head is sized to the room's load and chosen for cold-weather output. Below-grade rooms lose heat steadily into the ground, which the load calculation accounts for.
Who issues permits in Northglenn?
The City of Northglenn's building division issues the permits, and the contractor pulls them. We confirm the mechanical and electrical requirements for your address.
Where does condensate go from a head below grade?
Where gravity drainage to daylight is not possible, a small condensate pump lifts the water to a drain or outside. We plan the path before choosing the head location.

