Heat Pump Repair, Maintenance and Installation in Brighton, CO

An iced coil, cool air in heat mode, a furnace that runs all the time. We find out why before anything gets replaced.

Heat pump outdoor unit in the side yard of a Brighton ranchThe same house in a thermal rendering
Daylight and thermal views of the same house: where it loses heat sets the load.

Last Updated: November 2026

Last Updated: November 2026

Brighton's housing is newer than most of the north metro, and plenty of homes already have a heat pump, often added beside a gas furnace. So many of the calls we get here are not about buying one. They are about one that has stopped behaving: a coil caked in ice, cool air in heat mode, a gas bill that jumps because the furnace is doing all the work.

Sundog handles heat pump repair, maintenance and heat pump installation in Brighton. A repair visit starts with the cause, not a part, and when the fix is costly we price repair against replacement in writing.

What we hear from Brighton owners

Ice that will not clear

Light frost that melts every so often is normal. A solid sheet for days is not, and the cause can be a sensor, the control board, low charge, airflow or water pooling under the unit.

The furnace runs all winter

In a dual-fuel house, a heat pump that has quietly stopped heating hands everything to the furnace. You notice it on the gas bill before you notice it in the house.

Cool air from the vents

During a defrost cycle the air can feel cool for a few minutes. Cool air that lasts points to a stuck reversing valve, low charge or a control problem. A repair visit sorts which.

An older AC to replace

Homes that still run a central AC and furnace from the late 1990s are reaching the point where a heat pump replacement or dual fuel is the sensible next step.

Services in Brighton

Keep it running

Heat pump repair for defrost, charge, electrical and control faults, and maintenance visits with coil cleaning, drain checks and charge and airflow readings. Ductless systems too: ductless installs and repairs.

Replace or install

Replacement when repair no longer makes sense, cold-climate heat pumps chosen by their 5°F output, and dual-fuel systems that work with the furnace you have.

How a Brighton repair visit usually runs

  1. Listen and look

    What the system does, when it started, what the thermostat shows. Then the outdoor unit: ice pattern, pad, drainage, coil condition.

  2. Test, don't guess

    We clear ice before reading anything, then test sensors, the defrost board, pressures and electrical parts in turn, so the part we replace is the part that failed.

  3. Price it

    You get the cause and the price before work starts. If the repair is large on an aging system, you get the replacement option beside it.

  4. Prove it

    We run the system through the cycle that failed, such as a forced defrost, and check the furnace changeover before leaving.

What Brighton's housing tells us

Three local facts shape how heat pumps behave and get serviced here.

Late-1990s and newer

The American Community Survey puts Brighton's median year built at 1999, give or take two years. Systems installed in that era are now the age when repair-or-replace questions start, and many heat pumps added later as dual-fuel upgrades are reaching their first major repairs. Ducts are usually in better shape than in older suburbs, so the work centers on the equipment.

Gas heat, with heat pumps added

About 78% of occupied homes heat with utility gas and about 20% with electricity. In a gas house with a heat pump added, a failed heat pump does not leave you cold, because the furnace takes over. That hides problems, which is why yearly maintenance and a look at winter gas use catch failures early.

Utilities and permits

The City of Brighton lists United Power for electricity and Xcel Energy for natural gas, so the rebate programs that apply depend on your address. Brighton also spans Adams and Weld counties. Most repairs need no permit. Replacements and new installs do, and we confirm the permit office for your address.

Before you call

A few checks take minutes and sometimes solve the problem. If they don't, they still help us arrive with the right parts.

Inside the house

Look at the thermostat mode and any message on it. Check the filter: a clogged one starves the indoor coil and can make a heat pump trip or ice. Check the breakers for the outdoor unit and the air handler or furnace. Note whether the furnace is running more often than it used to.

At the outdoor unit

Look at the ice pattern. Frost across the coil that clears every hour or so is defrost doing its job. Ice thickest at the bottom, or a block on the pad, points to drainage or a failed defrost. Clear snow away from the sides, but leave the coil alone. Our frost and defrost article shows the difference.

Repair or replace?

When a repair is costly, these are the things we weigh with you.

Repair usually wins when

The system is under about ten years old, the failed part is a sensor, capacitor, contactor or board, the refrigerant is current, and the heat pump heated the house well before it failed. A maintenance checklist keeps it that way.

Replacement starts to win when

A compressor or coil has failed on an older system, it runs on a phased-out refrigerant, or it never kept up in cold weather. Then we price a cold-climate replacement beside the repair so you can compare.

Why we work this way

  • Ice, cool air and short cycling each have several possible causes, and the symptom alone does not prove one.
  • Testing parts in order means you pay for the part that failed, not the three around it.
  • Placement problems, like a pad in a low spot, get fixed with the repair so the fault does not come back next winter.
  • When repair and replacement are close, both go in writing with the reasons.
  • Maintenance readings from each visit give you a record, so a slow decline in charge or airflow shows up before it becomes a winter failure.

Inside a Brighton heat pump defrost repair

Heat pump outdoor unit raised on riser feet, coil clear of ice
Brighton: Heat pump outdoor unit raised on riser feet, coil clear of ice.
The same scene in a thermal rendering
The same scene in a thermal view.
Project price
$690
On site
3.5 hours
Where
Brighton
The house
Late-1990s ranch, dual-fuel system

A heat pump frosts up in winter and clears itself every so often; that is normal. A solid sheet of ice that sits there for days is not. That is what this late-1990s Brighton ranch had. A heat pump had been added to the gas furnace about ten years before, and with the outdoor unit iced over, the furnace was doing all the heating.

Ice has several possible causes, so we didn't guess. We cleared the coil first with a hose and a short run in cooling, since nothing reads true under ice. Then we tested the defrost control board with its sensor input bypassed. The board started a defrost on cue, so it stayed. The coil sensor, checked against a thermometer clamped beside it, read well out of range. With the coil clean, pressures and superheat in heat mode looked right, which ruled out a refrigerant leak.

We replaced the sensor and its clip. The second fix came from where the unit sat: a grade-level pad in a low corner on the north side, open to the wind across the lot, where meltwater pooled and froze back onto the bottom of the coil. We gave the line set a little slack and lifted the unit onto 6-inch riser feet so water drains away.

Before leaving we forced a defrost, watched it start and end, and confirmed the furnace changeover at the thermostat.

Brighton repair and service prices

These are Sundog's company ranges, the same in every area we serve. A repair visit gives you the cause and the price before work starts.

WorkSundog's typical range
Heat pump repair, routine$150 to $1,200
Heat pump repair, major components$1,500 to $3,500
Ductless repair$150 to $1,500
Heat pump maintenance visit$100 to $200
Cold-climate ducted heat pump, suitable existing ducts$13,000 to $25,000

Nearby areas

Commerce City

Southwest, with housing from the mid-2000s on average and many systems still on their first equipment. Commerce City service area.

Thornton

West, a large city of late-1990s homes where furnace failures often turn into conversions. Thornton service area.

Northglenn

Farther west, with mid-1970s housing where comfort on different levels is the usual question. Northglenn service area.

Tell us what the heat pump is doing

Tell us what you see, when it started and whether the furnace is carrying the house. A photo of the outdoor unit and the model label helps us come prepared with the likely parts. Call (719) 417-2475 or request a visit.

Get an Estimate

Heat pump questions in Brighton

What does a heat pump repair cost in Brighton?

Sundog's typical range for routine heat pump repair is $150 to $1,200, and major components run $1,500 to $3,500. Ductless repairs run $150 to $1,500. We give you the cause and the price before any work starts.

Is ice on my heat pump normal?

A light frost that clears every so often is normal in damp cold. A solid sheet that stays for hours or days is not. Turn the system to emergency or furnace heat and call us, rather than chipping at the coil.

Why did my gas bill jump if the house is still warm?

In a dual-fuel house the furnace takes over when the heat pump stops heating, so the house stays warm while the gas use climbs. A repair visit checks whether the heat pump is running and defrosting as it should.

Does Xcel's heat pump rebate apply in Brighton?

It depends on your electric utility. The city lists United Power for electricity and Xcel for gas, and rebate programs follow the utility. We check what applies to your address before an installation estimate is final.

How often should a heat pump be serviced?

Once a year is the usual rhythm, with the coil, drain, electrical parts, charge and airflow checked. A system that heats most of the winter benefits from a visit before the heating season.

Nearby areas

Get an estimate for your Brighton house

Tell us about the house and the rooms that give you trouble. We come back with a first range from our typical rates and a time for the site visit.

CallGet an Estimate