Electric Furnace to Heat Pump Swaps in Four Square Mile, CO

Most homes here already heat with electricity. A heat pump keeps that fuel and saves resistance heat for the hours that need it.

Heat pump outdoor unit in the side yard of a Four Square Mile townhomeThe same house in a thermal rendering
Daylight and thermal views of the same house: where it loses heat sets the load.

Last Updated: November 2026

Sundog installs and replaces heat pumps in Four Square Mile, the unincorporated pocket of Arapahoe County between Denver and Aurora. If your townhome or condo still heats with an electric furnace, the change here is usually a swap rather than a fuel conversion: no gas line to cap and no flue to retire. What decides the job is the closet the air handler has to fit in, the circuit already feeding it and where the outdoor unit can sit.

Our visit covers a room-by-room load calculation, duct and airflow checks and a panel check before anything is priced. Sundog's typical range for a cold-climate ducted heat pump on suitable existing ducts is $13,000 to $25,000, and your number comes from the site visit and the written estimate. Permits here usually come from the county rather than either neighboring city, and we confirm that for your address first.

What brings Four Square Mile owners to a heat pump

Four calls we expect from this part of the metro, and the first thing each one needs.

The electric furnace runs and the bill shows it

Resistance elements turn each kilowatt-hour into one unit of heat. A heat pump moves heat from outside instead and calls on its own strip only in the coldest hours or during defrost. Our guide to backup heat shows how that staging is set.

The AC is failing and the furnace is just as old

In an all-electric home the air handler and outdoor unit work as a matched pair, so both usually change together. We check whether the existing ducts and closet suit the new air handler before pricing either half.

The HOA wants to see the outdoor unit first

Attached homes often need exterior equipment approved before it goes on order. We give you the unit's dimensions and a placement sketch to send in, and plan the outdoor unit placement around patios, fences and shared walls.

One room never keeps up

A bedroom over a garage or a loft under the roof can need its own zone. A single ductless head carries that room while the main system carries the rest of the home.

Heat pump services in Four Square Mile

Sundog handles the full range of heat pump work for homes in Four Square Mile:

How a Four Square Mile job usually runs

  1. Address check

    We confirm whether the property sits in unincorporated Arapahoe County, which utility serves the meter and whether an HOA reviews exterior equipment.

  2. Site visit

    Load calculation, static pressure at the air handler, the closet's width, depth and door opening, and the panel along with the heavy circuit that feeds the old furnace.

  3. Written estimate

    Model numbers and low-temperature capacity, any duct or electrical work, the permit, removal, the pad or stand and start-up checks, each on its own line.

  4. Approvals and permits

    HOA sign-off for the outdoor unit where it applies, then mechanical and electrical permits through the authority for your address.

  5. Install and start-up

    Old equipment out, air handler set, lines run and tested, backup staged, readings recorded and left with you ahead of the inspection.

What we know about Four Square Mile homes

Four Square Mile is defined more by its boundaries than by its age, and those boundaries shape three parts of the job.

Housing from around 1990

Census estimates put the median year built here at 1990, give or take two years, which makes the typical home younger than Denver's or Englewood's. A system from that era may be on its second outdoor unit while the closet, duct trunk and wiring are still original. That is why we measure the closet and the circuit before choosing equipment, rather than assuming a newer box fits the old space.

More electric heat than its neighbors

About 52.6% of occupied homes in Four Square Mile heat with electricity and 44.6% with utility gas. In Denver the split runs the other way, with 60.8% on gas. For an electric-heat home the comparison is direct: a heat pump replaces resistance heating with a system that moves heat, and keeps resistance only as backup. For the gas homes here, the choice between dual fuel and all-electric follows the furnace's age and condition.

County permits, city mailing addresses

The area takes its name from the four square miles bounded by Quebec Street, Mississippi Avenue, Havana Street and Yale Avenue, with Parker Road running through it, and Arapahoe County governs it. Denver lies to the north, west and south and Aurora to the east, so a mailing address can name a city while the permit comes from the county's Building Division. Aurora's own programs, such as F-3, follow Aurora's mapped areas, so we check eligibility for your address instead of assuming it.

Like-for-like electric furnace or heat pump

A like-for-like electric furnace is the cheaper box to buy. Here is what each path leaves you with after the install.

Electric furnace and AC, like for likeCold-climate heat pump
How it heatsResistance elements all winterMoves outdoor heat; backup strip only when needed
CoolingA separate AC condenserThe same outdoor unit
Closet and ductsSame footprintAir handler chosen to fit the same closet
ElectricalLarge existing circuit reused as isBreaker matched to the smaller backup, plus an outdoor circuit
What we check firstElement and blower conditionLoad, airflow, closet size and the panel

Swapping an electric furnace for a heat pump in Four Square Mile

Compact air handler fitted in a townhome hall closet
Four Square Mile: Compact air handler fitted in a townhome hall closet.
The same scene in a thermal rendering
The same scene in a thermal view.
Project price
$13,600
On site
2 days
Where
Four Square Mile
The house
Circa-1990 townhome with electric furnace

Fewer than half the homes in Four Square Mile heat with gas, so original electric furnaces turn up in its circa-1990 townhomes and condos more than in most of the metro. This two-story townhome, about 1,250 square feet, had 15 kW of resistance elements in a hall closet and a 2-ton AC that no longer kept up. Winter bills were high and summer comfort was going.

Because the house was already all-electric, a heat pump here was a swap rather than a fuel conversion: no gas line to cap and no flue to deal with. The load calculation confirmed 2 tons. We kept the closet, the ducts and most of the wiring. A like-for-like electric furnace was the cheaper box, but it keeps a house on resistance heat.

The closet set the limits. We measured the width and door opening first and chose an upflow air handler that fit the existing footprint, carried in on a hand truck through the narrow hall. It had 8 kW of backup, so the heavy existing circuit got a breaker and wire termination matched to the smaller load, with a new 25-amp circuit for the outdoor unit. The 2-ton cold-climate unit went on a low pad inside the fenced patio, cleared with the HOA in advance, and a 25-foot line set reached it.

We staged the backup with an outdoor lockout and commissioned airflow, charge and defrost, then the county's inspection followed.

What the furnace closet decides

In a townhome the air handler usually lives in a hall closet with a standard door, and that closet sets the limits before the load calculation does. We measure three things: the opening the cabinet has to pass through, the floor space it has to stand on and the height under any shelf or return plenum. An upflow or multi-position air handler often fits the same footprint as the old electric furnace, but heat pump cabinets can run taller, so the supply transition gets planned at the visit rather than on install day.

The circuit matters just as much. An old 15 kW furnace sits on a heavy circuit, and a heat pump air handler with a smaller backup strip needs a breaker and termination matched to its own nameplate. We note the existing wire size and breaker on the estimate, so you can see why the electrical line reads the way it does.

Rebates for a Four Square Mile address

Incentives here follow the utility account and the address, not the mailing city.

Xcel Energy

Xcel runs a residential heat-pump rebate whose eligibility depends on the address, the equipment and the installer path, with its own installation and application deadlines. Check the current program dates; we confirm what applies before the estimate is final, and the incentive checklist lists the paperwork.

Federal credit

The federal 25C tax credit ended for systems installed after 2025, so it no longer factors into a new installation. Running cost then comes down to your electric rate and the backup settings, which our operating cost guide explains.

Start with the closet and the bill

Tell us the home type, where the air handler sits and whether an HOA reviews exterior equipment. We start with a first range from our typical rates and book the visit. Call (719) 417-2475 or get an estimate.

Get an Estimate

Heat pump questions in Four Square Mile

Does Aurora or Denver issue the permit for a Four Square Mile home?

Usually neither. Most of the area is unincorporated Arapahoe County, so mechanical and electrical permits go through the county's Building Division. Addresses near the edges can fall inside a city, so we confirm the jurisdiction for your address before the estimate.

What does a heat pump cost in Four Square Mile?

The same company ranges apply here as across our area. Sundog's typical range for a cold-climate ducted heat pump on suitable existing ducts is $13,000 to $25,000, and one ductless zone runs $4,500 to $9,500. Closet size, backup heat, panel work and line-set length move the number, which comes from the site visit and the written estimate.

Will a heat pump air handler fit in my townhome's furnace closet?

Often, yes. We measure the closet's width, depth and door opening and choose an air handler that fits that footprint. Where the closet is tight, we show you the options before anything is ordered.

Do I still need backup heat with a cold-climate heat pump?

Yes, sized to the gap. Even a cold-climate unit loses output on the coldest nights and pauses heating during defrost. In an all-electric home the backup is a strip in the air handler, staged and locked out above a set outdoor temperature.

Can my HOA limit where the outdoor unit goes?

An HOA can set rules for where exterior equipment sits and how it looks. We give you the unit's dimensions, color and a placement sketch to submit, and we hold the order until the approval comes back.

Nearby areas

Get an estimate for your Four Square Mile house

Tell us about the house and the rooms that give you trouble. We come back with a first range from our typical rates and a time for the site visit.

CallGet an Estimate