Ducted Heat Pumps and Duct Repair in Littleton, CO

A heat pump is only as good as the air it can move. In Littleton we test the ducts before we size the equipment.

Heat pump outdoor unit in the side yard of a Littleton split-levelThe same house in a thermal rendering
Daylight and thermal views of the same house: where it loses heat sets the load.

Last Updated: November 2026

Last Updated: November 2026

If some rooms in your Littleton house run cold in winter and warm in summer, a new heat pump alone will not fix them. The cause is usually air that never arrives: a crushed return, leaking joints, a branch too small for the room at the end of it.

Sundog approaches heat pump installation in Littleton by testing the duct system first, with a static-pressure reading at the blower and a look at the runs we can reach, alongside the room-by-room load and the panel check. Any duct fix appears on the written estimate as its own line, separate from the equipment.

What brings Littleton owners to us

One level never matches the others

Split-level and tri-level plans put bedrooms at the end of the longest runs. A heat pump supplies air at a lower temperature than a furnace, so a short branch shows up as a cold room.

The return whistles

Noise at the return grille usually means the blower is pulling through too little opening. It is one of the first things we measure, because it caps what any new system can deliver.

Furnace and AC both tired

Many owners here are replacing a furnace and AC from the same era and want to move to a heat pump or dual fuel in one step.

A room the ducts never reached

A converted porch, an addition or a lower-level den with no supply. One ductless head often fits better than extending the trunk.

Services for Littleton homes

Ducted systems

Ducted heat pump installation with any return, sealing or branch work found on the visit, replacement of older heat pumps, and cold-climate equipment picked by its 5°F output.

Everything around them

Dual fuel with a kept furnace, ductless zones for rooms outside the duct system, repairs and yearly maintenance that includes airflow readings, not just a filter change.

How a Littleton job usually runs

  1. Test

    Static pressure at the blower, a look at the return path and any crawlspace runs, and notes on which rooms run hot or cold. We also check the panel and walk the side yards for the outdoor unit's spot.

  2. Size

    A room-by-room load calculation, done after we know whether the ducts will be repaired, so the equipment matches the house as it will be.

  3. Fix, then install

    Duct work first, equipment second. Most single-system installs take one to four days on site, longer when duct work is part of the job.

  4. Retest and inspect

    We retest static pressure after commissioning, the permit inspection follows, and the readings stay with you.

Littleton houses and the ducts inside them

Three things about Littleton guide what we check first.

Early-1980s housing

The American Community Survey puts Littleton's median year built at 1982, within a year. Houses from that period often have the duct systems they were built with, sized for a furnace that pushed hot air hard. A heat pump depends on airflow far more, which is why our Littleton estimates often include return or sealing work.

Mostly gas, a solid electric share

About 69% of occupied homes heat with utility gas and about 29% with electricity. The gas homes usually weigh dual fuel against all-electric. The electric homes often have an air handler already, and the job becomes a heat pump replacing resistance heat on ducts that may need the same attention.

Three counties, one city

Littleton spreads across Arapahoe, Douglas and Jefferson counties, and a Littleton mailing address is not always inside city limits. Inside the city, permits go through Littleton's own building division. Outside it, the county handles them. We confirm the permit authority for your address before scheduling.

Common duct fixes and what they solve

Static pressure tells us how hard the blower works to move air through the system. When it reads high, the fix is usually one of a few, and each goes on the estimate as a separate line so you can see what it costs and why it is there. Our ductwork guide goes deeper.

What we findWhat we doWhat it solves
Crushed or kinked flex returnReplace with rigid round ductLow airflow and a noisy return
Leaking trunk and branch jointsSeal with masticAir lost to crawlspaces and walls
One return for a multi-level houseAdd a second return upstairsUpper rooms that never settle
Filter rack that lets air slip pastSeal or replace the rackDust on the coil, lower capacity

Repair the ducts or add a zone

Not every comfort problem is solved in the basement. After the test, the choice usually falls one of two ways.

Repair the ducts

When static pressure is high and the losses trace to a crushed return, open joints or an undersized branch, fixing them helps every room the system serves. It is usually the lower-cost route when the trunk is sound, and it lets the heat pump run at the airflow it was rated for. We retest afterward so you see the change.

Add a zone

When the ducts test fine and one level still drifts, the cause is the house: sun on west glass, an attic over the bedrooms, a half-buried family room. A motorized damper zone or a ductless head treats that level on its own thermostat. Our zone planning guide shows how heads are sized.

Why ducts come before equipment

  • Sizing on a restricted duct system copies the restriction onto new equipment, and the cold rooms stay cold.
  • With the return fixed, the load calculation often lands below the old nameplate, which can lower the equipment cost.
  • A variable-speed blower lasts longer and runs quieter when it is not working against high static pressure.
  • Retesting after the work proves the fix with a number, not a feeling, and the before and after readings stay with you.
  • We check rebate eligibility for your address and equipment before the estimate is final.

What a ducted heat pump job in Littleton looks like

New rigid round return duct with sealed joints in a crawlspace
Littleton: New rigid round return duct with sealed joints in a crawlspace.
The same scene in a thermal rendering
The same scene in a thermal view.
Project price
$18,900
On site
3 days
Where
Littleton
The house
Early-1980s tri-level split-level

Littleton's housing stock centers on the early 1980s, and plenty of it is split-level, which means ducts that wander through crawlspaces nobody visits. In this tri-level the upstairs bedrooms were cold in January and stuffy in July, and the return grille whistled. The owners wanted to replace a tired furnace and AC with a heat pump.

We tested before we sized. The static pressure read about 0.9 inches of water column, and a duct leakage test pointed to the crawlspace, where the main flexible return was crushed flat under a joist. A heat pump needs more airflow than a furnace to heat comfortably, so putting one on that duct system just moves the problem to new equipment. The old 3.5-ton nameplate wasn't the answer either: with the return fixed, the load calculation landed at 3 tons.

So the duct work came first. We replaced about 22 feet of crushed return with 14-inch rigid round duct, sealed around 40 joints with mastic, and added a second return in the upstairs hallway. Then a variable-speed air handler with a 10 kW backup strip went in the utility room, and a 3-ton cold-climate heat pump went on a new pad at the side of the house on a 35-foot line set. The strip was locked out above a set outdoor temperature so it only helps when the heat pump needs it.

We retested static pressure and leakage after the work, passed the city inspection and left the readings with the owners.

Littleton heat pump prices

Sundog uses one set of company ranges across every area. In Littleton, the duct work and whether you keep the furnace move the figure most. Your price comes from the visit and the written estimate.

Ducted heat pump

Sundog's typical range for a cold-climate ducted heat pump on suitable existing ducts is $13,000 to $25,000. Duct repairs found on the visit are priced as their own lines.

Dual fuel and ductless

Dual fuel with a new gas furnace runs $19,000 to $28,000. A single ductless zone runs $4,500 to $9,500. The cost estimator gives a first range.

Nearby areas

Englewood

North, a close neighbor with one of the oldest housing medians we serve, from the mid-1960s. Englewood service area.

Highlands Ranch

Southeast, with late-1990s housing where furnace and AC often reach the end together, and Douglas County permits. Highlands Ranch service area.

Greenwood Village

Northeast, a city of homes and offices, with mid-1990s housing on average and its own city permits. Greenwood Village service area.

Find out what your ducts can carry

Tell us which rooms bother you and in which season. A photo of the furnace label and the return grille helps. We start with a first range from our typical rates, then book the visit that measures the house. Call (719) 417-2475 or book a visit.

Get an Estimate

Heat pump questions in Littleton

How much does a heat pump cost in Littleton?

Sundog's typical range for a cold-climate ducted heat pump on suitable existing ducts is $13,000 to $25,000, with any duct repairs priced separately. Dual fuel with a new furnace runs $19,000 to $28,000. The site visit and written estimate set your number.

Can a heat pump use the ducts in my split-level?

Usually yes, once we know they can carry the airflow. We read static pressure and check the return and the longest runs. Many split-levels need a larger or second return rather than new ductwork.

My address says Littleton. Do I pull permits from the city?

Only if the house is inside city limits. Some Littleton mailing addresses fall in unincorporated Arapahoe, Douglas or Jefferson County, where the county issues permits. We confirm the authority for your address.

Will fixing the ducts make the upstairs comfortable?

It removes the most common cause. If the upstairs still gains heat through west windows or the attic, we look at a second zone or a ductless head and tell you which before you decide.

Does duct work add days to the install?

It can. Most single-system installs take one to four days on site. Return replacement and sealing usually add time at the front, because the ducts are finished before the new equipment is set.

Nearby areas

Get an estimate for your Littleton house

Tell us about the house and the rooms that give you trouble. We come back with a first range from our typical rates and a time for the site visit.

CallGet an Estimate